產品資訊 - distribution grip dead-line ->accessory for power line

登入

加入會員

求助

China National Electric Negineering Technology Co.,LTD

回首頁

公司簡介

產品櫥窗

影音視聽

寄出詢問函

聯絡我們

	Recommended Results

distribution grip dead-line

產品分類 :

電子電工->電類產品->電線電纜->電源線配件

產品規格

Model No:	NZ*

產品描述

The characteristics of
Uniform stress distribution, stress free concentration, can well protect the cable.
In not more than under the premise of lateral pressure strength, fiber optic cable to cable have bigger grip strength, can bear large tension.
Is emphatically not below cable to cable 95% of rated tensile strength (RTS), does not damage the OPGW cable at the same time.
High quality aluminum clad steel material, improve the mechanical properties and anticorrosion performance of the clamp.
The technical requirements
Accord with DL/T766-2003 optical fiber composite overhead ground wire (OPGW) with a ground type hardware technical conditions and test methods.
composition
Inner hinge beforehand, outer hinge, thimble, PD type hangs Taiwan, u-shaped ring, etc.
use
Will bear all the tension, optical fiber composite overhead ground wire (OPGW) to connect to on the tension tower.
Ordering instructions
According to the antibody strength rating of the OPGW cable and outer diameter to select suitable strain clamp.
Number of configuration: 1 set/terminal tower (including gantry);2 sets/tension tower.
Inner screw in the process of the hinge to the line clip and OPGW outer layer of ground to the contrary, the standard configuration according to the OPGW outer ground for a right-handed, such as for left-handed, should indicate in the order contract.
After this line under the whole tension, suggested that the disposable use.
Give the first connected to the tower hardware model.
Clamp strength is divided into 70 kn, 100 kn and 120 kn.